Knowledge

Home > Knowledge > Content

Silicone rubber products new test mode key considerations

Qingdao Steady Machinery Co.,Ltd | Updated: Jun 19, 2015

Test mode key considerations

When we receive a new molds require proofing pilot die, we are always eager to try out sooner as a result and pray for smooth so as not to waste time and causing trouble. but we must remind the two points:

A. check tooling machines open die and recognize successful mold all the institutions, if the problem immediately after you stop the action to avoid unnecessary serious, no problem with reciprocating action multiple times, on to the next action.

B. for shot out action Qian, on mold lock force confirmed, first die finished only shot to 80% full die. no problem Shi to normal conditions try, confirmed samples meet customer standard, again for next action level pressure test, high pressure in normal of conditions Xia high 20PMa low voltage in normal conditions Xia low 10 PMa. to for mold of analysis, please remember all of action must low down with began for.